Free Shipping In All Countries
Panier 0
BMS 30A/40A/60A 50.4V  12S  Lithium Ion  BMS  Battery Protection Board LED Balance Charge  for Electric Bike Vehicles

BMS 30A/40A/60A 50.4V 12S Lithium Ion BMS Battery Protection Board LED Balance Charge for Electric Bike Vehicles

Prix régulier $37.99 Prix réduit $86.99 Prix unitaire par
Taxes incluses. Frais de port calculés à la caisse.

1) With balance

2) With Balance/Signal Cables;

3) With Temperature switch

4) The BMS charge with discharge port are same version

5) Detection circuit (over-discharge, over-current , and load short circuit)

6) Welcome OEM





1. Battery assembly notice before BMS installation:

Each cell must match well before BM installation (Battery internal resistance differences within 5 Milliohm, voltage within 0.03 V , capacity vary within 50 mAh). Lfepo4 cell, voltage between 2.6V~3.5V,Li-ion cell, voltage between 3~4V.

If the cells are full charged,please discharge them to the standard voltage range.Cell first parallel then series.

2. Connection instruction of BMS wires:

(a) Connect B- big short wire to battery general negative end( B-and Discharge port with multi-holes, you can use one large wire to connect one hole or several middle wires to connect each hole.)

(b) Connect signal/Balance wires: remove the balance wires from BMS before you assembly. Start from B-, first wire connect to B-,the second balance B1 wire connect to the first cell positive, B2 connect to second cell positive,balance wires soldering should be according to the order of B-,B1,B2,B3....B12

(c) Make sure all of the wires correct before you plug the connector into BMS:use multi meter to test each neighbouring series voltage ,if not, the BMS will burn.( Li-ion voltage less then 4V,Lifepo4 voltage less than 3.5V)

(d) Test the battery general negative voltage between battery general positive whether equal the total voltage.

(e1)Plug the balance wires to BMS(plug low bit to high bit), Connect Charge /Discharge large wires to “ C-” Connect red big wire to battery general positive end. Test the discharge total voltage again.




 

 

S-version-wires-instruction

 


Origin: CN(Origin)
Condition: New
Type: Voltage Regulator
Model Number: PCM-12S6060LIPH24
Application: Electric Toy
Operating Temperature: -40-85
Supply Voltage: 50.4v
Dissipation Power: 50
Package: TQFP
is_customized: Yes


Partager ce produit