Free Shipping In All Countries
Carrito 0
10S 80A/100A/120A BMS Li-ion 42V large high current 42V PCM with Same Discharge Port  for electric bike electric

10S 80A/100A/120A BMS Li-ion 42V large high current 42V PCM with Same Discharge Port for electric bike electric

Precio habitual $72.99 Precio de oferta $180.99 Precio unitario por
Impuesto incluido. Los gastos de envío se calculan en la pantalla de pagos.

Features

 

1) With balance

2) With Balance/Signal Cables;

3) WithOUT Temperature switch

4) The BMS charge with discharge port are the same.

5) Detection circuit (over-discharge, over-current , and load short circuit)

6) With Led Showing

7) Welcome OEM

 

 

Parameters

 

wire-diagram

1. Battery assembly notice before BMS installation:

Each cell must match well before BM installation (Battery internal resistance differences within 5 Milliohm, voltage within 0.03 V , capacity vary within 50 mAh). Lfepo4 cell, voltage between 2.6V~3.5V,Li-ion cell, voltage between 3~4V.

If the cells are full charged,please discharge them to the standard voltage range.Cell first parallel then series.

2. Connection instruction of BMS wires:

(a) Connect B- big short wire to battery general negative end( If B-and Discharge port with multi-holes, you can use one large wire to connect one hole or several middle wires to connect each hole.)

(b) Connect signal/Balance wires: remove the balance wires from BMS before you assembly. Start from B-, first wire connect to B-,the second balance B1 wire connect to the first cell positive, B2 connect to second cell positive,balance wires soldering should be according to the order of B-,B1,B2,B3....B10

(c) Make sure all of the wires correct before you plug the connector into BMS:use multi meter to test each neighbouring series voltage ,if not, the BMS will burn.( Li-ion voltage less then 4V,Lifepo4 voltage less than 3.5V)

(d) Test the battery general negative voltage between battery general positive whether equal the total voltage.

(e1) Plug the balance wires to BMS(plug low bit to high bit), Connect wire to “ C-” connect large wire to "P-"   Connect TWO red wires (one same size match with C- for charge,one same size match with P- for discharge) to battery general positive end.  Test discharge total voltage again.

 

 

 

 

 

 

S-version-wires-instruction


Origin: CN(Origin)
Condition: New
Type: Voltage Regulator
Model Number: PCM-10S120120LIPH28
Application: Electric Toy
Operating Temperature: -40-85
Supply Voltage: 42v
Dissipation Power: 50
Package: TQFP
is_customized: Yes


Compartir este producto