Free Shipping In All Countries
Warenkorb 0
BMS 16S 80A/100A/ 120A Li-ion PCM  Battery Protection Board BMS  for Electric Bike Battery Cell Pack

BMS 16S 80A/100A/ 120A Li-ion PCM Battery Protection Board BMS for Electric Bike Battery Cell Pack

Normaler Preis $74.99 Sonderpreis $172.99 Einzelpreis pro
inkl. MwSt. zzgl. Versandkosten

Features

1) With balance

2) With Balance/Signal Cables;

3) With Temperature switch

4) The BMS charge with discharge port are same 

5) Detection circuit (over-discharge, over-current , and load short circuit)

6) With Led Showing

7) Welcome OEM

 

Parameters

 

wire-diagram

1. Battery assembly notice before BMS installation:

Each cell must match well before BM installation (Battery internal resistance differences within 5 Milliohm, voltage within 0.03 V , capacity vary within 50 mAh). Lfepo4 cell, voltage between 2.6V~3.5V,Li-ion cell, voltage between 3~4V.

If the cells are full charged,please discharge them to the standard voltage range.Cell first parallel then series.

2. Connection instruction of BMS wires:

(a) Connect B- big short wire to battery general negative end( B-and Discharge port with multi-holes, you can use one large wire to connect one hole or several middle wires to connect each hole.)

(b) Connect signal/Balance wires: remove the balance wires from BMS before you assembly. Start from B-, first wire connect to B-,the second balance B1 wire connect to the first cell positive, B2 connect to second third cell positive,balance wires soldering should be according to the order of B-,B1,B2,B3....B16

 

(c) Make sure all of the wires correct before you plug the connector into BMS:use multi meter to test each neighbouring series voltage ,if not, the BMS will burn.( Li-ion voltage less then 4V,Lifepo4 voltage less than 3.5V)

(d) Test the battery general negative voltage between battery general positive whether equal the total voltage.

(e1) Plug the balance wires to BMS(plug low bit to high bit), Connect Charge /Discharge large wires to “ P-” Connect red big wire to battery general positive end. Test the discharge total voltage again.

 

 

 

 

 

 

 

S-version-wires-instruction


Origin: CN(Origin)
Condition: New
Type: Voltage Regulator
Model Number: PCM-16S120120LIPH28
Application: Electric Toy
Operating Temperature: -40-85
Supply Voltage: 67.2v
Dissipation Power: 50
Package: TQFP
is_customized: Yes


Diesen Artikel teilen