Free Shipping In All Countries
Warenkorb 0
10S 10A li-ion 37V 42V  BMS PCM  battery protection board bms pcm  for electric bike battery cell pack

10S 10A li-ion 37V 42V BMS PCM battery protection board bms pcm for electric bike battery cell pack

Normaler Preis $30.99 Sonderpreis $55.99 Einzelpreis pro
inkl. MwSt. zzgl. Versandkosten

This BMS used  li-ion rechargeable battery protection IC 

It can also used for 10s 37V Li-ion electric bike battery packs.

features

1) With balance

2) With Balance/Signal Cables;

3) With Temperature switch

4) The BMS charge with discharge port is the same;

5) Detection circuit (over-discharge, over-current , and load short circuit)

6) Welcome OEM

parameter

 

10S10A

 

instruction

 

TB2KzBmpVXXXXc2XpXXXXXXXXXX_!!152430381

 

  

1. Battery assembly notice before BMS installation:

Each cell must match well before BM installation (Battery internal resistance differences within 5 Milliohm, voltage within 0.03 V , capacity vary within 50 mAh). Lfepo4 cell, voltage between 2.6V~3.5V,Li-ion cell, voltage between 3~4V.

If the cells are full charged,please discharge them to the standard voltage range.Cell first parallel then series.

2. Connection instruction of BMS wires:

(a) Connect B- big short wire to battery general negative end( If B-and Discharge port with multi-holes, you can use one large wire to connect one hole or several middle wires to connect each hole.)

(b) Connect signal/Balance wires: remove the balance wires from BMS before you assembly. Start from B1, first wire connect to first cell positive,the second balance B2 wire connect to the second cell positive, B3 connect to third cell positive,balance wires soldering should be according to the order of B1,B2,B3....B10

(c) Make sure all of the wires correct before you plug the connector into BMS:use multi meter to test each neighbouring series voltage ,if not, the BMS will burn.( Li-ion voltage less then 4V,Lifepo4 voltage less than 3.5V)

(d) Test the battery general negative voltage between battery general positive whether equal the total voltage.

(e) Plug the balance wires to BMS(plug low bit to high bit), Connect Charge /Discharge large wires to “ P-” Connect red big wire to battery general positive end. Test the discharge total voltage again.

application

10S Li-ion18650,LiCoO2,LiMn2O4,Li(NiCoMn)O2 rechargeable batteries

10S Lipo rechargeable batteries

notice

1) Please note that the input and output voltage, and load current conditions for power protection board does not exceed the electrical parameters of the allowable power consumption;

2) special attention to the load current can not work long hours between maximum continuous operating current and over-current protection current;

3) When connecting the battery ,it may not discharge. In this case, connect the charger can be restored to normal working condition;

4) Although the BMS built-in electrostatic protection circuit, but please do not hand touch  when BMS in the working condition, so as to avoid damage from static electricity protection board.

SMT3

payment

payment


Condition: New
Type: Voltage Regulator
Package: TQFP
Dissipation Power: 50
Model Number: BMS-10S1010LI766
Application: Electric Toy
Operating Temperature: -40-85
Supply Voltage: 37v
is_customized: Yes


Diesen Artikel teilen